YamahaEnduro.com  
 



Original YamahaEnduro.com forum (From 2006) 13,185 archived posts


Go Back   YamahaEnduro.com > General Discussion > Yamaha Enduro General Discussion
Register FAQ Calendar Mark Forums Read

Yamaha Enduro General Discussion For General Posts about Yamaha Enduros

Reply
 
Thread Tools Display Modes
Old 02-09-2018, 09:32 PM   #11
Midlife motor
Enduro Pro
 
Midlife motor's Avatar
 
Join Date: Dec 2013
Location: Mesa, Az
Posts: 775
Midlife motor May possibly Own a  Yamaha Enduro?


Default Por 15

I have had great success with POR 15. The first tank had almost no rust, so it came out great. The second tank had a previous poor job of another sealant done by another person. The POR did a great job on that one too.

On the second tank, two pinholes were discovered after putting in the second stage chemical, which is designed to remove rust. I did some research and felt the POR 15 would seal the pin holes from the inside. Sure enough it did. Just to make sure, after the sealant cured I sanded a small amount of paint off the outside of the tank around each pinhole and applied Quick Steel. Quick Steel is like a putty. It gets unbelievably hard and is easy to sand down.

One year later and not a drop has leaked from either pin hole.
__________________
It is better to remain silent and be considered a fool than to open your mouth and remove all doubt.
Midlife motor is offline   Reply With Quote
Old 02-13-2018, 06:36 AM   #12
Larry$
Enduro Master
 
Larry$'s Avatar
 
Join Date: Feb 2011
Location: Colorado
Posts: 1,763
Larry$ May possibly Own a  Yamaha Enduro?


Default



I took the gas tank from my RT3 #2 to a local radiator shop. Old school hot rod guy. He brazed up the leaking seams, cleaned the tank (don't know how or what he used) and then coated the inside with the green Northern Fuel Tank Liner product. It has held up well so far.




.
__________________
Formerly DTbop

1973 RT3
1981 IT-465
(1/2) 1982 IT-465
2001 Indian Scout







II Timothy 2:15 - "Study to shew thyself approved unto God, a workman that needeth not to be ashamed, rightly dividing the word of truth."

This applies not only to the Bible, but to your shop manual as well.
(borrowed from Dan's On-line Motorcycle Repair Course)
Larry$ is offline   Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 10:07 PM.

          

Donations  
             Current_Site_Fund   vBulletin or XenForo?


Powered by vBulletin® Version 3.6.10
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.